Proper installation is critical to the performance of your new residential generator. Eastern Shore Power Systems will install your system correctly, test its performance, and explain its capabilities.

Eastern Shore Power Systems installation team is highly trained and adheres to all local,  state, and national electrical and plumbing codes when making both electrical and fuel connections for your generator. You can rest assured that the result will be a properly installed, safe, and reliable standby power system.

Schedule an installation today by calling Eastern Shore Power Systems at 678-283-5614 or filling out the Contact Us Form

Generac Products Link – CLICK Here

Our 9-Step process:

1. Site evaluation

Critical information is gathered to determine power requirements, load calculation showing actual load, location of generator, size of generator needed along with appropriate transfer switch. This is done with our detailed process, we will give and explain everything that is involved with the installation of your new generator and we wont leave until you completely understand.

2. Quote process and diagram

A complete and thorough explanation of the equipment required for the power needs of the buyer is provided. We will then provide you with a detailed printout of the proposal and then again make sure there are no questions remaining. Spec sheets and brochures are given so you have a full understanding of the process. REMEMBER this visit is for educational purposes. We will not employ pressure to you to buy and will give you time if needed to think over this purchase, we understand this can be a large expenditure. We look forward to meeting you and finance plans are available.

3. Permitting (if necessary)

If the installation is in an area that requires permitting, a permit is applied for and granted prior to any work.

4. HOA approval (if necessary)

Many Home Owner’s Associations require approval prior to installing a standby generator. We are available to provide needed information to the HOA on your behalf.

5. Install concrete pad

Concrete pads are provided and carry a lifetime warranty for most all generators.

6. Electrical systems install and inspection

Incorrect electrical installation can result damage to the equipment not covered under warranty. There is a right way and a wrong way to wire a standby generator system with transfer switch. Passing inspection doesn’t always mean it is installed correctly. We painstakingly follow all national and local codes to ensure you get the best installation possible.

7. Plumbing install and inspection

As with installation, there is a right way and a wrong way to plumb a standby generator. Even if a job passes inspection, that doesn’t mean it is plumbed correctly for a standby generator. Experience is the best guide to be certain of proper installation. From short black pipe installation’s to long underground gas lines we have the experience to get the job done right.

8. Gas provider services setup

Standby Generators fueled by natural gas run best with elevated pressure.  This sometimes requires an upgraded meter from the natural gas provider. We will determine your gas needs on the initial visit and provide documentation and direction to get this done with your gas provider. If propane is needed we will size your gas needs and assist you to coordinate with your propane supplier for tank size and installation.

9. Startup and Customer Training